Propeller Installation - NINCOAIR GLIDER SPORT ARF Manual

NH92011 RTF – NH92012 ARF GLIDER SPORT

6. PROPELLER INSTALLATION

1. Install propeller on to motor shaft, secure
with nut, see attached picture.
2. Secure the spinner onto propeller adapter
with 2mm x 6 mm screws.
7. FLYING CHECKING
Switch on the transmitter, make sure throttle is
pulled all the way back, other control and trim
part should be place in the middle, plane power
should be the last to switch on.
Before taking off, check to make sure aileron
and main wing, elevator and horizontal
stabilizer, fin and rudder to be paralleled, if not,
please adjust connect hole of throttle and arm or by releasing or tightening throttle.
8. BEFORE YOUR FLIGHT
Fly the model when the wind is calm. Pick an open area away from buildings, road or tall trees. Gusty
winds not only make it hard to control your plane but also may cause crash, loss or accident.
Charge a battery pack fully. Before storing the battery pack for longer than a week, charge or
discharge a li-po battery till about half-full. Do not store a fully-discharged or fully-charged li-po
battery pack for a long time.
+/- 60min.
With a battery fully charged
With a battery not charged enough
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
11