HP Pavilion XF315 Reference Manual page 125
Notebook pc
Hide thumbs
Also See for Pavilion XF315:
- Information note (2 pages) ,
- Troubleshooting & repair manual (42 pages) ,
- Startup manual (70 pages)
Table of Contents
Advertisement
Modem Reference Information
Command
Function (Conexant)
+FMR
Report modem version, revision, or date.
+FPR=n
Set DTE/modem interface rate in bits/sec: 0=automatic detection (default).
+FRH=n
Receive data with HDLC framing.
Receive data.
+FRM=n
+FRS=n
Receive silence, n×10 ms.
+FTH=n
Transmit data with HDLC framing.
+FTM=n
Transmit data.
+FTS=n
Stop transmission and wait, n×10 ms.
Voice Commands
+FCLASS=8
Select voice mode.
Set report ring cadence and timing of RING event code:
+VDR=a,b
a=0 disables ring cadence reporting, a=1 enables.
b sets report content: 0=DROF and DRON messages only.
+VDT=a,b
Set report control tone cadence:
a=0 disables ring cadence reporting, a=1 enables.
b=0 reports CPOF and CPON messages only.
+VDX=a
Select speakerphone half-duplex (a=0) or full duplex (a=1).
+VGM=n
Set microphone gain of speakerphone function (0 to 255).
+VGR=n
Set gain for received voice samples (0 to 255).
Set speaker gain of speakerphone function (0 to 255).
+VGS=n
+VGT=n
Set volume (120 to 135).
+VIP
Initialize all voice parameters to defaults.
Set initial value for DTE/modem inactivity timer (0 to 255 seconds).
+VIT=n
+VLS=n
Select sources/destinations for analog data.
+VNH=n
Set automatic hangups: 0=enable, 1=disable, 2=disable automatic hangups in non-voice modes.
+VPR=n
Set DTE/modem interface rate (0=autobaud).
+VRA=n
Set delay between ringbacks before modem assumes remote station is off hook (0 to 255 x 0.1 sec).
+VRN=n
Set delay between ringbacks before modem assumes remote station is off hook (0 to 60 sec).
+VRXn
Start voice reception: 0=start without periodic tone production, 1=start with periodic tone production.
+VSD=a,b
Set silence detection sensitivity and required period of silence before modem reports silence at end of
voice receive.
+VSM=a,b,c,d
Set voice and silence compression methods, and voice sampling rate.
+VSP=a
Disable (a=0) or enable (a=1) speakerphone.
+VTD=n
Set beep duration (1 to 500 x 0.01 sec).
+VTR
Start voice transmission and reception.
+VTS=string
Send voice tones.
+VTX
Start voice transmission.
AT* Commands
*B
Display black-listed numbers.
*D
Display delayed numbers.
Reference Information
Reference Guide
125
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
