Table of Contents
Advertisement
Step 1
Take down the pedestal.
Loosen the locking screws ⑦ anticlockwise to make it separate.
Step 2
Mark pedestal ③ mounting hole sites on the mounting surface ①, and dig three expansion bolt
bottom holes on the mounting hole sites. Then insert expansion bolts ② into the mounting
holes and lock them firmly.
Step 3
Adjust pedestal ③ location (lead out cable from lateral cable slot if it adopts side cable outlet).
Align the bolt fixing hole of device pedestal with the expansion bolt fixing hole of the mounting
surface; insert the self-tapping screws ④ into the expansion bolts and lock them firmly to fix
the pedestal on the mounting surface (If it is top cable outlet, lead out cable from the outlet
hole on the mounting surface after the pedestal is fixed).
Step 4
Install dome body ⑤ and enclosure ⑥.
Insert the enclosure into the pedestal together with the dome body, twist locking screw ⑦
clockwise and fix it preliminarily; Rotate enclosure and dome body to proper monitoring
location; finally tighten the locking screw and make it firmly fixed.
Step 5
Connect device cable to back-end HCVR device.
So far, the device installation and cable connection have been completed, you can check
device monitoring image via back-end coding device.
3.2 Mobile Camera Installation (2)
Generally the installation location of this type of mobile camera is front windshield.
Figure 3-4
7
Advertisement
Table of Contents
