Table of Contents
Advertisement
5.
Remove the USB board (2) from the alignment clip built into the base enclosure.
6.
Remove the USB board and cable.
Reverse this procedure to install the USB board.
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b.
Hard drive cover (see
c.
Keyboard (see
d.
Top cover (see
e.
Base enclosure bracket (see
Remove the power connector cable:
1.
Disconnect the power cable (1) from the system board.
70
Chapter 4 Removal and replacement procedures
Battery on page
44), and then remove the following components:
Hard drive on page
Keyboard on page
59)
Top cover on page
62)
USB board on page
Memory module on page
53)
69)
Spare part number
606890-001
45)
ENWW
Advertisement
Table of Contents
