Table of Contents
Advertisement
Optical drive cable
NOTE:
The optical drive cable and bracket are included in the base enclosure spare part kit, spare
part number 606884-001.
Before removing the optical drive cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b.
Hard drive cover (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
Remove the optical drive cable:
1.
Disconnect the optical drive cable (1) from the system board.
2.
Remove the Phillips PM2.0×3.0 screw (2) that secures the optical drive cable to the base
enclosure.
3.
Remove the optical drive cable bracket (3).
4.
Remove the optical drive cable (4).
Reverse this procedure to install the optical drive cable.
68
Chapter 4 Removal and replacement procedures
Battery on page
44), and then remove the following components:
Hard drive on page
Optical drive on page
Keyboard on page
59)
Top cover on page
62)
Memory module on page
53)
58)
45)
ENWW
Advertisement
Table of Contents
