c.
Remove the two Phillips PM2.0×3.0 screws (1) and the four Phillips PM2.5×5.0 screws (2)
that secure the display panel to the display enclosure.
d.
Lift the top edge of the display panel (1) until it rests at an angle.
e.
Remove the display panel (2) from the display enclosure. The display panel is available
using spare part numbers 614179-001 (for use only with computer models equipped with
WWAN capability) and 598226-001 (for use only with computer models not equipped with
WWAN capability).
8.
If it is necessary to replace the display panel cable:
a.
Release the support strip (1) that secures the display panel cable to the display panel.
b.
Disconnect the display panel cable (2) from the display panel.
c.
Release the webcam/microphone module cable (3) from the display panel. (The webcam/
microphone module cable is attached to the display panel with double-sided tape.)
ENWW
Component replacement procedures
83