Table of Contents
Advertisement
2.
Release the wireless antenna cables (3) from the opening (4) in the base enclosure.
CAUTION:
support the display assembly can result in damage to the display assembly and other computer
components.
3.
Remove the four Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
NOTE:
4.
Remove the display assembly (3).
5.
If it is necessary to replace the display bezel or any of the display assembly internal components:
a.
Remove the Mylar screw covers (1).
b.
Remove the two Phillips PM2.5×6.0 screws (2) that secure the display bezel to the display
assembly.
80
Chapter 4 Removal and replacement procedures
Support the display assembly when removing the following screws. Failure to
One of the screws on the left hinge secures a display panel ground loop (2).
ENWW
Advertisement
Table of Contents
