Table of Contents
Advertisement
Power button board
Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b.
Hard drive cover (see
c.
Keyboard (see
d.
Top cover (see
Remove the power button board:
1.
Turn the top cover upside down, with the front toward you.
2.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the power button board to the top
cover.
3.
Remove the power button board (2).
Reverse this procedure to install the power button board.
ENWW
Battery on page
44), and then remove the following components:
Hard drive on page
Keyboard on page
59)
Top cover on page
62)
Memory module on page
53)
Component replacement procedures
Spare part number
607976-001
45)
65
Advertisement
Table of Contents
