Security Cable Bracket - HP Pavilion DM1-2060 Maintenance And Service Manual

Remove the multi board:
1. Disconnect the multi board cable (1) from the system board.
2. Remove the 2 PM2.0×3.5 screws (2) that secure the multi board to the base enclosure.
3. To remove the multi board and cable (3), lift up the inside edge and slide the multi board out at a
45-degree angle.
Reverse this procedure to install the multi board.

Security cable bracket

Description
Security cable bracket (included in power connector spare part kit, part number 591851-001)
Before removing the security cable bracket, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. hard drive cover (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
e. Display assembly (see
64 Chapter 4 Removal and replacement procedures
Battery on page 36).
WLAN module on page
Drives on page 44).
Keyboard on page 47).
Top cover on page 50).
Display assembly on page
38).
58).
Spare part number