Frigidaire CFIF3054TS Use & Care Manual page 39

Problem
Soil not completely removed after
self clean.
Appliance is not level.
Cannot move appliance easily.
Appliance must be accessible for
service.
Oven light does not work.
Cause / Solution
Self clean was interrupted. Review instructions on
Excessive spills on oven bottom. Remove excessive spills before starting self clean.
Failure to clean soil from the oven frame, the door liner outside the oven door gasket,
and the small area at the front center of the oven bottom. These areas are not in the
self-cleaning area, but get hot enough to burn on residue. Clean these areas before
starting the self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon
brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
Other Problems
Be sure the floor is level, strong, and stable enough to adequately support the range.
If the floor is sagging or sloping, contact a carpenter to correct the situation.
Poor installation. Place the oven rack in the center of the oven. Place a level on the
oven rack. Adjust the leveling legs at the base of the appliance until the rack is level.
Kitchen cabinet alignment may make range appear not level. Be sure cabinets are
square and have sufficient room for appliance clearance.
Cabinets not square or are built in too tightly. Contact the builder or installer to make
the appliance accessible.
Carpet interferes with appliance. Provide sufficient space so the appliance can be
lifted over carpet. Installation over carpet is not advised.
See the installation instructions for guidelines specific to your appliance.
Be sure the oven light is secure in the socket. See
page 34.
BEFORE YOU CALL
"Self Clean" on page 27.
"Replacing the Oven Light" on
39