Frigidaire FFEF3056TW Installation Instructions Manual

Frigidaire FFEF3056TW Installation Instructions Manual

Hide thumbs Also See for FFEF3056TW:

Advertisement

Available languages

Available languages

Quick Links

30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Clearances and Dimensions
1. Provide adequate clearances between the range and adjacent combustible surfaces.
2. Location—Check location where the range will be installed. Check for proper electrical supply, and the stability
of the floor.
3. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT
VIEW
30"
(762 mm)
Minimum
Minimum to wall
1"
on either side of
(25 mm)
range above
36'' (914 mm)
height.
36"
(914 mm)
(762 mm)
RANGE
OVERALL
DIMENSIONS
48"
(1219 mm)
Maximum
49"
(1245 mm)
Maximum
Door Open
*30" (762 mm) MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACE AND THE BOTTOM OF AN UNPROTECTED
WOOD OR METAL CABINET; OR 24" (610 mm) MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT
LESS THAN 1/4" (6 mm) FLAME RETARDANT MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015"
(0.4 mm) STAINLESS STEEL, 0.024" (0.6 mm) ALUMINUM OR 0.020" (0.5 mm) COPPER. 0" (0 mm) CLEARANCE IS THE MINIMUM FOR
THE REAR OF THE RANGE. FOLLOW ALL DIMENSION REQUIREMENTS PROVIDED ABOVE TO PREVENT PROPERTY DAMAGE,
POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOP AND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE
LOCATED ABOVE THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN
BE REDUCED BY INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" (127 mm) BEYOND THE
BOTTOM OF THE CABINETS.
P/N 316259203 REV C (1409)
(For 4 Wire, 60 Hz. Systems)
30"
(762 mm)
Minimum to
cabinets on
18"
either side of
(457 mm)
range.
30"
0" (0 mm) clearance below cooking top and at rear of range.
25- 3/4"
30"
(654 mm)
(762 mm)
(940 mm)
29- 7/8"
(759 mm)
SIDE
VIEW
13"
330 mm
Maximum depth
for cabinets
above range top.
25"
635 mm
36
1/8"
(3 mm)
2-5/8" (67 mm) for models
equipped with warmer drawers
3-1/2" (89 mm) for models
equipped with storage drawers
1
Centerline of
range
All dimensions for electrical outlet location
are maximum.
Dashed cubed area
shows where the electrical outlet must be
installed
for flush to the wall installation.
11"
(279 mm)
22"
(559 mm)
6"
(152 mm)
Wall
Edge
English - Pages 1-4
Français - Pages 5-8

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire FFEF3056TW

  • Page 1 30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS (For 4 Wire, 60 Hz. Systems) INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Clearances and Dimensions 1.
  • Page 2: Before Starting

    30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS (For 4 Wire, 60 Hz. Systems) IMPORTANT SAFETY Before Starting Tools You May Need INSTRUCTIONS For leveling legs and Anti-Tip Bracket: If the information in this manual is not followed exactly, a fire or electrical shock may result causing property •...
  • Page 3: Electrical Connection Requirements

    30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS (For 4 Wire, 60 Hz. Systems) location of the screw holes, shown in template. (17 mm) B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8" (3 mm) pilot hole where screws are to be located. If bracket is to 2.
  • Page 4: Model And Serial Number Location

    30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS (For 4 Wire, 60 Hz. Systems) Model and Serial Number Location The serial plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area.
  • Page 5 NOTICE D’INSTALLATION POUR CUISINIÈRE ÉLECTRIQUE DE 762mm (30") (pour les systèmes 60 Hz à 4 fils) L'INSTALLATION ET L'ENTRETIEN DOIVENT ÊTRE EFFECTUÉS PAR UN INSTALLATEUR QUALIFIÉ IMPORTANT: À CONSERVER POUR CONSULTATION PAR L'INSPECTEUR EN ÉLECTRICITÉ. LISEZ ET CONSERVEZ CES INSTRUCTIONS POUR CONSULTATION FUTURE. Dimensions et espaces libres 1.
  • Page 6: Directives Importantes De Sécurité

    NOTICE D’INSTALLATION POUR CUISINIÈRE ÉLECTRIQUE DE 762mm (30") (pour les systèmes 60 Hz à 4 fils) DIRECTIVES IMPORTANTES DE Avant de commencer SÉCURITÉ Outils dont vous aurez besoin Pour les pattes de mise à niveau et le support de contrerenversement Un feu ou une électrocution peut survenir et être la cause de dommages à...
  • Page 7 NOTICE D’INSTALLATION POUR CUISINIÈRE ÉLECTRIQUE DE 762mm (30") (pour les systèmes 60 Hz à 4 fils) 11/16” pour un montage sur le plancher. Marquez l’emplacement des (17 mm) trous des vis indiqués sur le gabarit. Côté de la cuisinière B. Percez les trous d’alignement et fixez le support - 2.
  • Page 8 NOTICE D’INSTALLATION POUR CUISINIÈRE ÉLECTRIQUE DE 762mm (30") (pour les systèmes 60 Hz à 4 fils) Emplacement du no. de modèle / no. de série La plaque signalétique est localisée sur la surface à droite du devant du cadre du fourneau, à la partie inférieure du panneau derrière le devant du tiroir réchaud ou de rangement.

Table of Contents