Fan/heat sink assembly
Fan/heat sink assembly (includes replacement thermal material)
To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the left side
of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a
temperature sensor and is designed to turn on automatically when high temperature conditions exist.
These conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan/heat sink assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
Remove the battery (see
Remove the service cover (see
Disconnect the hard drive cable from the system board (see
Disconnect the WWAN antenna cables from the WWAN module (see
Disconnect the WLAN antenna cables from the WLAN module (see
Remove the following components:
Top cover (see
System board (see
Remove the fan/heat sink assembly:
Turn the system board upside down, with the front toward you.
Disconnect the fan cable (1) from the system board.
Following the 1, 2, 3 sequence stamped into the fan/heat sink assembly, loosen the three
Phillips PM2.0×4.0 captive screws (2) that secure the fan/heat sink assembly to the system
Battery on page
Keyboard on page
Top cover on page
System board on page
Service cover on page
Hard drive on page
WLAN module on page
Component replacement procedures
Spare part number