System Board - HP Envy 14-1050 Maintenance And Service Manual

Remove the power connector cable:
1. Disconnect the power extension cable (1) from the battery connector board.
2. Release the power extension cord (2) from the system board. (The power extension cord is
attached to the system board with double-sided tape.)
3. Disconnect the power connector cable (3) from the system board.
4. Release the power connector (4) from the alignment clip built into the base enclosure.
5. Remove the power connector cable.
Reverse this procedure to install the power connector cable.

System board

NOTE: The system board spare part kit includes replacement thermal material. Replacement thermal
material is also available in the Thermal Material Kit, spare part number 634366-001.
Description
For use only on computer models equipped with an Intel Core i7 processor
For use only on computer models equipped with an Intel Core i5, i3, or Pentium processor
68 Chapter 4 Removal and replacement procedures
Spare part number
608365-001
608364-001