Table of Contents
Advertisement
Before using for the first time
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the pro-
gramme.
If spots appear on crockery and glass-
ware:
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
Decrease the rinse aid dosage.
28
Switch the dishwasher off with the
button, if it is switched on.
Press the Start button in and whilst
holding it in switch the dishwasher
on using the button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the button 3 times.
The indicator will flash rapidly three
times at intervals.
The dosage set will show in the display
after the symbol.
The flashing sequence will appear in
the display.
This indicates the factory default setting
3.
Use the Start button to select the set-
ting required.
Each press on the button moves you
up a level. After reaching the highest
value the counter starts from the be-
ginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Advertisement
Table of Contents
