Chicago Electric POWER TOOL 94362 Assembly And Operating Instructions Manual page 19

If the Carbon Brushes appear to be in good condition, but only dirty, they can be
cleaned by rubbing with a pencil eraser. If there are large scratches on the
Carbon Brushes, replace both Carbon Brushes immediately with approved
replacement Carbon Brushes from Harbor Freight Tools. To reinstall the Carbon
Brushes, insert them into the two Brush Holders (44). Turn the Carbon Brushes
vertically so they will fit properly into the Brush Holders. Then, replace the Brush
Covers. (See Figure K.)
6. Store the Saw in a clean, dry location.
FIGURE K
SKU 94362 For technical questions, please call 1-800-444-3353.
MOTOR HOUSING
(#41)
BRUSH COVER (#42)
CARBON BRUSH (#43)
BRUSH HOLDER (#44)
Page 19