• Make sure that the product
control knobs are switched off
after every use.
Safety when working with
electricity
• Any work on electrical
equipment and systems should
only be carried out by author-
ised or qualified persons.
• In case of any damage,
switch off the product and
disconnect it from the mains.
To do this, turn off at the fuse
box.
• The appliance must be
installed so that it can be
completely disconnected from
the mains easily after installa-
tion by the isolation switch.
• Do not bend or trap cable
against hot surfaces during
install.
• Make sure that fuse rating
is compatible with the product.
•
Do not switch the oven
i
off at the mains isolation
switch immediately after
cooking. Cooling fan contin-
ues to run for up to 20-30
minutes (approx) even after
the oven control is turned off.
• Keep all ventilation slots
clear of obstructions, as this
may cause premature failure of
the oven element.
• Do not allow the oven to
cool with the door open. Even if
the appliances door is only
open a little, front panels of
adjacent units could become
damaged over time.
Safety and cleaning
•
sive cleaners or sharp metal
scrapers to clean the oven door
since they can scratch the
surface, which may result in the
shattering of the glass.
•
the appliance is switched off
before replacing the lamp to
avoid the possibility of an
electric shock.
•
i
household room illumination.
•
ers for cleaning.
• The appliance must not be
installed behind a decorative
door.
Exclusive to Howdens Joinery.co
User manual LAM3503/4
Do not use harsh abra-
WARNING Ensure that
Do not use oven light for
Do not use steam clean-
Page _ 8