Table of Contents
Advertisement
Hardware Preparation and Installation
Install the device at once after you take it out of the anti-static package. If you need
to lay down the device, place it back in the anti-static package. Do not lay the
device on the shelf or cabinet.
Monitor the temperature and humidity of the equipment room. Warm air decreases
the humidity but increases the static electricity in the room.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage
circuits or shorten their life. Before touching the module or electronic components,
make sure that you are working in an ESD safe environment.
2.6
M.2 AHCI or NVMe SSD Installation and
Removal
This section provides procedures on how to install or remove M.2 AHCI or NVMe SSDs
from a PCIE-6002 card.
2.6.1
M.2 AHCI or NVMe SSD Module Installation on the PCIE-6002
Card
PCIE-6002 provides four (4) sets of the hardware as shown in
To install M.2 AHCI or NVMe SSD modules on a PCIE-6002 card:
1. Install M2.5 screw and standoff in the PCB hole location based on the length of the M.2
module.
32
Hardware Preparation and Installation
NOTICE
PCIE-6002 Installation and Use (6806800U70B)
Figure
1-1.
Advertisement
Table of Contents
