SMART PCIE-6002 Installation And Use Manual page 16

Safety Notes
representative system to show compliance with the above mentioned requirements. A
proper installation in a compliant system will maintain the required performance. Use only
shielded cables when connecting peripherals to assure that appropriate radio frequency
emissions compliance is maintained.
Operation
Product Damage–Surface of the Product
High humidity and condensation on the product surface causes short circuits.
Do not operate the product outside the specified environmental limits. Make sure the
product is completely dry and there is no moisture on any surface before applying power.
Overheating and Product Damage
Operating the product without forced air cooling may lead to overheating and thus damage
of the product.
When operating the product, make sure that forced air cooling is available in the enclosure.
Data Corruption
If power to the unit is removed while a firmware update is in progress to the card flash
memory, the changes will not be saved, and worse, the flash memory may be corrupted. In
such case the card is likely to remain in non-operable state and will require reconditioning
by qualified repair services.
Installation
Damage of Circuits
Electrostatic discharge and incorrect installation and removal of the product can damage
circuits or shorten their life.
Before touching the product or electronic components, make sure that your are working in
an ESD-safe environment.
Product Damage
Incorrect installation of the product can cause damage of the product.
Only use appropriate tools when installing/removing the product to avoid
damage/deformation to the card and/or PCB.
16 PCIE-6002 Installation and Use (6806800U70B)
Safety Notes