Table of Contents
Advertisement
• Operation is not guaranteed on all USB power sources.
Make sure to test the power source before using it.
• The transmitter cannot be used when connected to a USB
device that possesses communication functions, such as
a computer.
For details on BATTERY TYPE setting, see "Setting the
battery type (BATTERY TYPE)" (page 11).
Setting the Transmission
Channel
The transmitter provides groups of interference-free
channels. When using multiple microphones and
transmitters at the same time (simultaneous multi-channel
operations) within the same area, selecting the same group
and using a channel within that group can prevent signal
interference.
To set the transmission channel on the transmitter, first you
select the group and channel using the RF indicator and
scanning functions on the receiver. Next you set the group
and channel parameters to match the setting on the
receiver.
Notes
• Certain transmission channels cannot be used with the
wireless remote control function.
For details on transmission channels that do not support
the wireless remote control function, refer to the
frequency lists.
• When selecting the channel, "(INCOMPATIBLE WITH
RF REMOTE)" will slide across the display for
transmission channels that cannot be used with the
wireless remote control function.
• When a transmission channel that cannot be used with
the wireless remote control function is selected,
"RESTRICTED BY GP/CH SETTING" appears on the
RF REMOTE screen and the wireless remote control
function cannot be used. To enable use of the wireless
remote control function, select transmission channels for
which "(INCOMPATIBLE WITH RF REMOTE)" does
not appear during channel selection.
Selecting the group/channel
Notes
• Before doing this procedure, use the BAND function
(see page 10) to set the transmitter to the bandwidth of
the receiver you are using.
• The setting for this function cannot be changed during
actual signal transmission.
Set the transmitter group (GP) and channel (CH) as
follows:
For details on groups and channels included in each
frequency band, refer to the frequency lists.
For details on menu operation, see "Basic Menu
Operations" (page 9).
1
Turn off the power, and then while holding down the
SET button, turn the power on.
The signal transmission stops.
6
Advertisement
Table of Contents
