Table of Contents
Advertisement
Power Supply
The transmitter can operate on two LR6 (size AA) alkaline
batteries continuously for about 5.0 hours at 25 °C (77 °F).
Installing the batteries
1
Squeeze the battery-holder tabs inward (in the
direction of the arrows) and slide out the battery
holder.
2
Insert new batteries, making sure the polarities are
correct, and then return the battery holder to its
original position.
Battery indication
The power status is indicated by eight level indications.
Replace both batteries when the battery indication starts to
flash.
Be sure to check the expiration date printed on the new
batteries before using them.
Notes
• When BATTERY TYPE is set to TYPE1, the power
status is indicated based on the use of new LR6 (size
AA) Sony Alkaline batteries. An incorrect indication
may result when a different kind of batteries, a different
brand of batteries or old batteries are used. If you plan to
use other kind of batteries than alkaline, set the
BATTERY TYPE function according to the type of
batteries to be used.
• If you plan to use the transmitter for a long period of
time, it is recommended that you replace the batteries
with brand new ones.
For details on BATTERY TYPE setting, see "Setting the
battery type (BATTERY TYPE)" on page 12.
Setting the Transmission
Channel
The transmitter provides groups of interference-free
channels. When using multiple microphones and
transmitters at the same time (simultaneous multi-channel
operations) within the same area, selecting the same group
and using a channel within that group can prevent signal
interference.
To set the transmission channel on the transmitter, first you
select the group and channel using the RF indicator and
scanning functions on the receiver. Next you set the group
and channel parameters to match the setting on the
receiver.
Notes
• Certain transmission channels cannot be used with the
wireless remote control function.
• "(INCOMPATIBLE WITH RF REMOTE)" will slide
across the display during group/channel selection for
transmission channels that cannot be used with the
wireless remote control function.
• When a transmission channel that cannot be used with
the wireless remote control function is selected,
"RESTRICTED BY GP/CH SETTING" appears on the
RF REMOTE screen and the wireless remote control
function cannot be used. When using the wireless remote
control function, select transmission channels for which
"(INCOMPATIBLE WITH RF REMOTE)" does not
appear during group/channel selection.
Selecting the group/channel
Notes
• Before doing this procedure, use the BAND function
(see page 11) to set the transmitter to the bandwidth of
the receiver you are using.
• The setting for this function cannot be changed during
actual signal transmission.
Set the transmitter group (GP) and channel (CH) as
follows:
For details on groups and channels, refer to "Sony Digital
Wireless Microphone System Frequency Lists" on the
supplied CD-ROM.
For details on menu operation, see "Basic Menu
Operations" on page 10.
1
Turn off the power, and then while holding down the
SET button, turn the power on.
The signal transmission stops.
2
Press the + or – button repeatedly until the GP/CH
indication is displayed.
6
Advertisement
Table of Contents
