Vacmaster VMVK1630SWC Manual page 11

30l 1600w
Table of Contents

Advertisement

3) Switch the vacuum cleaner to position II, as described in Switching ON/OFF. The moment you
switch on the power tool, the vacuum cleaner will also switch on. Once the electrical appliance
has been switched off, the vacuum cleaner switches off following a time lapse (around 5
second) to allow the suction tube to be emptied.
3. Dry & Wet Vacuum Operation
WARNING:
'SAFETY INFORMATION'.
1) Verify that the correct filter is installed for wet or dry vacuuming and the container latches are
secured.
2) Secure the locking end of the hose into the vacuum suction port.
3) Push the desired accessories onto the hose nozzle. The air flow regulation allows you to
change vacuum cleaner suction. For best cleaning results, fully close the air flow regulation
(Fig. 7).
4) Plug the power cord into a power outlet.
5) Turn on the motor by assigning the switch to the "I" ON position.
6) Once you have completed vacuuming, switch to the "O" OFF position and unplug the power
cord from the power.
For Dry Vacuuming:
WARNING:
CLEANER FILTER, ENSURE THAT THE POWER CORD IS UNPLUGGED AND
SWITCHED OFF.
1) To prepare your vacuum cleaner for dry vacuuming, install the cartridge filter over the filter cage
with the flat end of the filter towards the vacuum power head. Carefully push filter until it sits
flush forming a tight seal.
2) Place the filter retainer cap on top of cartridge filter over the raised lip and tighten the retainer
lock clockwise to secure against the internal filter cage (Fig. 8).
3) Fit the nylon pre-filter over the cartridge filter and secure with the draw string (Fig. 9).
4) Optionally, fully fit the dust bag flange onto the inlet stub. The Vacuum cleaner can we be used
with or without dust bags.
IMPORTANT: Check the filter regular for optimal performance. An old or blocked filter will reduce
suction performance.
For Wet Vacuuming:
1) To prepare your vacuum cleaner for wet vacuuming, remove the retainer cover and the dry use
cartridge filter and nylon pre-filter.
2) Carefully install the supplied foam filter over the internal filter cage, making sure the whole cage
is covered (Fig. 10).
WARNING:
DO NOT USE THE CARTRIDGE FILTER FOR WET VACUUMING.
DO NOT USE A DUST COLLECTION BAG FOR WET VACUUMING.
ENSURE YOU READ, UNDERSTAND AND APPLY SECTION ENTITLED
BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM
11
GB

Advertisement

Table of Contents
loading

Table of Contents