When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
Memory module (see
●
WLAN module (see
●
Processor (see
Remove the system board:
1.
Remove the RJ-11 connector (1) from the base enclosure clip.
2.
Disconnect the Bluetooth module cable (2) and the USB connector module cable (3) from the
system board.
3.
Remove the Torx T8M2.5×6.0 screw from the system board.
4.
Flex the left side of the base enclosure until the external monitor connector (1) and the heat sink
(2) are clear of the openings in the base enclosure.
5.
Lift the rear edge of the system board (3) until it rests at an angle.
80
Chapter 4 Removal and replacement procedures
Memory module on page
WLAN module on page
Processor on page
88)
53)
50)