Table of Contents
Advertisement
Setting Operating
Frequency of
Transmitter
Your remote control transmitter has code
switches which must be set in one of 32
possible code combinations. The five
levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up)
position. Do not use this setting. Change
the switch settings as follows:
1. Slide the five switch levers in the remote
control (transmitter) to your choice of
ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide
the levers firmly up or down.
2. When power is restored after installation
of the wall control, push and hold the fan
OFF button (
set the code in the receiver.
3. The sixth switch marked ON and I is for
dimming control of lights: Set switch to
ON to allow for dimming of the lights.
Set switch to I for no dimming of the
lights such as for fluorescent bulbs.
4. Install the batteries in the transmitter
battery compartment and replace the
battery cover.
Installation of Storage
Bracket
A storage bracket is provided for holding
your remote control when not in use
(Figure 26). If you desire to use the brack-
et, install it on a wall that is away from
excess heat or humidity.
Operation of Remote
Control
IMPORTANT
Fan installation must be completed,
including the installation of the fan
blades, before testing of the remote
control.
Your remote control has full control of your
fan and light (Figure 26).
NOTE: Prior to operation of the fan and
light from the remote control, set the
fan speed to HIGH ( .... ) and turn the
light ON (
).
) for 3 to 5 seconds to
1. To set the desired fan speed, hold the
FAN (
) button down, then press one
of the four buttons ( . , .. , ... , .... ) to oper-
ate your fan from low to high speeds.
2. To turn the light on and off, press the
LIGHT (
) button down, then press
one of the four buttons ( . , .. , ... , .... ) to
operate your light intensity from low to
high intensities.
Note: When turning the light on, light
will turn on at the light intensity previ-
ously selected.
COVER
WALL
BRACKET
SCREW
HOLES (2)
POWER
INDICATOR
LIGHT
FAN
BUTTON
LIGHT
BUTTON
Figure 26
14
TO INSTALL
BRACKET TO WALL:
SLIDE THE COVER UP
TO EXPOSE THE
SCREW HOLES FOR
INSTALLATION
HIGH TO LOW
BUTTONS
STORAGE
BRACKET
U.L. Model No.: CF205
Advertisement
Table of Contents
