Table of Contents
Advertisement
Rising Edge
Falling Edge
Undo Setup
5.6.2Help
Push the HELP button to display the Help menu which provides topics covering all the menu options
and controls of the oscilloscope. For detailed information about the Help system, refer to
2.2.
5.6.3Configuración por defecto
When you push the DEFAULT SETUP button, the oscilloscope will display the CH1 waveform and
remove all the others. When you are at the default setup, press F1 to Undo Preset. Then the
oscilloscope returns to the status before default setup. The table below gives the options, buttons
and controls that change settings at default setup.
Menu or System
Acquire
Cursor
Display
Horizontal
Math
FFT
Measure
Trigger (Edge)
DS2002A Series Digital Storage Oscilloscope User Manual
The oscilloscope displays Min, Mean and Positive Width automatic
measurements.
Display the rising edge.
Display the falling edge.
Let the oscilloscope recall the previous setup.
Option, Button or Knob
(Three mode options)
Averages
Run/Stop
Type
Source
Horizontal (amplitude)
Vertical (time)
Type
Persist
Format
Window Mode
Trigger Knob
Position
SEC/DIV
Operation
Source
Position
Vertical Scale
FFT Operation
Source
Window
FFT Zoom
Source
Type
Type
Source
Basic Operation
Configuración por
defecto
Normal
16
Run
Off
CH1
±3.2div
±4div
Vectors
Off
YT
Single-window
Level
0.00s
200μs
—
CH1-CH2
0div
20dB
CH1
Hanning
X1
CH1
None
Edge
CH1
Section
41
Advertisement
Table of Contents
