System Configuration Menu - HP 2133 Mini-Note Maintenance And Service Manual

System Configuration menu

NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select
Boot Options
Device Configurations
Built-In Device Options
To do this
●
Set an f9 and f10 delay when starting up.
●
Set the Express Boot Popup delay in seconds.
●
Enable/disable internal network adapter boot and set the boot mode (PXE).
● Enable/disable MultiBoot, which sets a boot order that can include most boot
devices in the system.
●
Set the boot order.
◦
1st boot device: USB devices
◦
2nd boot device: Notebook hard drive
◦
3rd boot device: Notebook Ethernet
●
Swap the functions of the
●
Enable/disable USB legacy support. When enabled, USB legacy support
allows the following:
◦ Use of a USB keyboard in Computer Setup even when your operating
system is not running.
◦
Startup from bootable USB devices, including a hard drive, diskette
drive, or optical drive connected by a USB port to the computer.
● Enable/disable fan always on while connected to an AC outlet.
●
Enable/disable SATA Native Mode.
● Enable/disable embedded WLAN Device Radio.
●
Enable/disable embedded Bluetooth.
● Enable/disable Wake on LAN.
●
Enable/disable Network Interface Controller (LAN)
NOTE: Always set the fan to 40% PWM while this item is enabled.
●
Enable/disable integrated camera.
● Enable/disable Wake on LAN.
●
Enable/disable the ExpressCard slot.
fn key and left ctrl key.
Computer Setup menus 61