Top Cover - HP 2133 Mini-Note Maintenance And Service Manual

Top cover

Description
Top cover
Before removing the top cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the keyboard (see
6. Remove the hard drive or solid-state drive (see
Remove the top cover:
1. Turn the computer upside down, with the front toward you.
2. Use a thin, flat tool to release the four rubber feet (1).
CAUTION:
releasing the rubber feet to prevent damaging the feet.
3. Remove the three Torx8 T8M2.5×10.0 screws (2) and the Torx8 T8M2.0×4.0 screw (3) that secure
the top cover to the base enclosure.
4. Turn the computer right-side up, with the front toward you.
5. Open the computer as far as possible.
6. Remove the Torx8 T8M2.5×10.0 screw (1) that secures the top cover to the base enclosure.
Battery on page
Keyboard on page
The rubber feet are attached to the base enclosure by tethers. Exercise caution when
32).
33).
Mass storage device on page
Component replacement procedures
Spare part number
482265-001
37).
39