HP 2133 Mini-Note Maintenance And Service Manual page 46

Hp 2133 mini-note: specifications

Hide thumbs Also See for 2133 Mini-Note:

Table of Contents

Remove the hard drive or solid-state drive:

Disconnect the drive cable (1) from the connector on the system board (2).

Remove the Phillips PM2.0×5.0 screw (1) and the two PM2.0×5.0 screws (2) that secure the drive

to the computer.

NOTE:

drives.

Grasp the Mylar tab (3) on the drive and slide the drive (4) to the left to release it from the drive

bay.

Remove the drive (5) from the drive bay.

Reverse this procedure to install the hard drive or solid-state drive.

Chapter 4 Removal and replacement procedures

The screw highlighted by callout (1) is captive in hard drives, non-captive in solid state

Table of Contents