Subscribe to Our Youtube Channel
Related Manuals for Clarke CFI 1800
Summary of Contents for Clarke CFI 1800
- Page 1 INFRARED WALL HEATERS MODEL NO: CFI 1800/1800L PART NO: 6939000 & 6939002 OPERATION & MAINTENANCE INSTRUCTIONS GC0715...
-
Page 2: Environmental Recycling Policy
INTRODUCTION Thank you for purchasing this CLARKE Infrared Wall Heater. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
2. Always check for damage before using the heater. Any damage should be properly repaired or the part replaced. If in doubt, DO NOT use the heater and consult your local Clarke dealer. 3. Never carry out any modifications to this product. If experiencing difficulty of any kind consult your local dealer. -
Page 4: Personal Safety
PERSONAL SAFETY 1. When the heater is to be operated in the presence of other people the user is responsible for informing those present of the safety precautions and of the hazards involved. 2. The heater is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge. -
Page 5: Electrical Connections
ELECTRICAL CONNECTIONS WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz. -
Page 6: Mounting The Heater
PREPARATION UNPACKING Remove heater from the carton and check for any damage sustained in transit. Notify your Clarke dealer immediately of any defects. MOUNTING THE HEATER The heater is resistant to splashing but should be sheltered from direct rainfall, as should the power cable, plug and supply outlet socket. If used outdoors, an awning, overhanging roof or other shelter should be used to protect from rain The heater must be mounted on a suitable wall at a height not less than 1.8m... -
Page 7: Operation
3. Ensure heating elements are free of dust (use compressed air to clean if possible. (Always wear a dust mask if performing this operation). 4. Refer to your Clarke dealer if the heater element or LED lamp need replacing. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 8: Fault Finding
Fuse blown. Replace if necessary and investigate the cause. If fuse blow repeatedly, consult your Clarke dealer. No power at socket Insert plug into a suitable outlet. socket. Input voltage incorrect. Ensure power supply matches the rating on the label. -
Page 9: Parts Diagram
PARTS DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 10: Parts List
PARTS LIST DESCRIPTION DESCRIPTION LED Surround Ring # Connector Cap Self-tapping Screw Control Box Cover LED Lens # Cable Clamp Side Cover Screw ST Screw # Star Washer LED Panel # Screw LED Sealing Ring # Spring Washer LED Bulb Assembly # LED Holding Bracket # Self-tapping Screw LED Housing #... -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the CFI 1800 and is the answer not in the manual?
Questions and answers