Install Side Panel; Install Base Grille - KitchenAid Stainless Series Owner's Manual

Tighten the four Torx®† 27 flat-head mounting screws to a
3.
torque of approximately 100 inch-pounds (11.3 Nm).
A. Torx® 27 flat-head mounting screws
B. 1/4" hex-head mounting screws

Install Side Panel

If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
For the inside side trim piece, slide the front edge of the routed
1.
side panel into the trim piece.
Nail the rear edge of the panel to the support board.
2.
A
A. Support board (mounted to back wall)
B. Cab side trim
B

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
To see whether the skirt is needed, place the base grille into
1.
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of 1/2" (1.27 cm) in
order to add the skirt.
:
NOTE
If the gap measures less than1/2" (1.27 cm), skip steps 3 and
4 of the instructions, and install the base grille only.
Remove the film from the base grille.
2.
Snap the skirt onto the base grille.
3.
A. Base grille
B. Skirt
Trim the skirt by scoring the proper "V" groove with a utility
4.
knife. Break the skirt at the score line.
A. "V" groove
25