Install Side Panel; Install Base Grille - KitchenAid KBLC36FMS02 Installation Manual

Door Alignment
1. Loosen, but do not remove, the four Torx
mounting screws and the two
in the top hinge.
2. Adjust the top hinge of the door to align it.
3. Tighten the Torx ®† 27 flat-head mounting screws to a torque of
approximately 100 inch-pounds (11.3 Nm).
4. Tighten the " hex-head screws.
B
®†
A. Torx 27 flat-head mounting screws
"
B. hex-head mounting screws

Install Side Panel

If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
A
A. Support board
B. Side trim piece
†®TORX is a registered trademark of Textron Innovations Inc.
22
®† 27 flat-head
" hex-head mounting screws
A
B

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1. To see if the skirt is needed, place the base grille into position.
Do not attach the base grille to the refrigerator. Measure the
distance between the bottom of the base grille and the floor.
The gap must be a minimum of
the skirt.
NOTE: If the gap measures less than
steps 3 and 4 of the instructions, and install the base grille
only.
2. Remove the protective film from the base grille.
3. Snap the skirt onto the base grille.
A. Base grille
B. Skirt
4. Trim the skirt by scoring the proper "V" groove with a utility
knife. Break the skirt at the score line.
A. "V" groove
" (1.27 cm) in order to add
" (1.27 cm), skip
A
B