Table of Contents
Advertisement
Installation
Figure 7.
A-Tech controller installation
2. Place the base temporarily over the wire hole opening
in the wall. Level the base and mark the screw locations
through the two provided mounting slots.
Figure 8.
Spot cooler grille
Figure 9.
Ducted system typical air patterns
SUPPLY
AIR OUTLET
90° / RIGHT ANGLE
14
STRAIGHT-THRU
NOTICE
Sensor Damage!
Do not touch the temperature sensor on the bottom left
corner of the thermostat. The sensor can be damaged if
handled improperly.
3. If using the supplied anchors, drill two 3/16 in. holes
and tap in the wall anchors. If only the screws are being
used, drill two 3/32 in. holes.
4. Fasten the base to the wall using the supplied screws.
5. Connect wiring between the thermostat and
equipment. See the A-Tech wiring instructions in
Section
"A-Tech 1.1 Programmable Thermostat," p. 22
and
"A-Tech 1.2 Programmable Thermostat," p.
6. Reinstall thermostat cover to base.
.75 in/19 mm
THICK
GASKET
IN/OUT
SAME FACE
22..
AH-SVX008C-EN
Advertisement
Table of Contents
