Table of Contents
Advertisement
Threading
44
7
Threading
Threading of all Looper Threads is done by the Air Threading System. Threading of the Needle Threads must
be performed in a specific sequence.
> Thread the Needle Threads from left to right.
7.1 Threading preparation
Before threading, make sure that the device is mechanically adjusted to the required stitch.
The machine has color-coded threading paths. Correct threading is ensured when following the color
markings.
Prerequisite:
•
The retractable thread guide is fully extended.
•
The needles are at the top position.
•
All threads and needles that are not needed for the particular stitch have been removed.
> Raise the presser foot.
– The Thread Tensions are released and the thread can be inserted without resistance.
> Place the thread cones on the respective spool pin.
2022-01 EN 5040062.0.04
Advertisement
Table of Contents
