Grizzly H0596 Instruction Sheet

EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
injury.
Always disconnect tool from
air to prevent unexpected
operation during service.
Always wear respirator when
Introduction
This 25,000 RPM air belt sander requires 90 PSI,
4 CFM, and / " x 13" sanding belts. Four-pack
3
8
sanding belts (Model H2322) can be purchased
separately for the Model H0596.
Inventory
A. Air Belt Sander ........................................... 1
B. / " x 13" Sanding Belts .............................. 2
3
8
C. Hex Wrench 3mm ...................................... 1
A
C
Figure 1
.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
INJURY HAZARD!
DUST HAZARD!
using this tool.
B
Model H0596.
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
#BL8253 PRINTED IN TAIWAN
MODEL H0596
AIR BELT SANDER
INSTRUCTION SHEET
Adjusting Platen and Attaching Belt
To adjust the platen:
1. Using the hex wrench, loosen the cap screw
and hex nut shown in Figure 2 and turn the
platen to the desired operating angle.
Platen
Figure 2. Loosening cap screw and hex nut.
2.
Make sure the platen and housing surfaces
(Figure 3A) are seated and flush with one
another. If these mounting surfaces are not
square, remove the platen from the housing
(Figure 3B) and reseat the platen and clamp
nut.
Platen
Housing
A
Figure 3. Squaring mounting surfaces.
3.
Tighten the cap screw and hex nut loosened
in Step 1.
Clamp
Nut
Mounting Surfaces
B