EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
injury.
Always disconnect tool from
air to prevent unexpected
operation during service.
Always wear respirator when
Introduction
This 8,000 RPM air sander requires 90 PSI and
6 CFM. Air inlet is
/
" NPT. Requires 3
1
4
sanding sheets. (You can cut a standard 9" x 11"
sanding sheet into thirds and trim each piece to
size.)
Inventory
A. Pneumatic Jitterbug Sander ....................... 1
Figure 1
.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
INJURY HAZARD!
DUST HAZARD!
using this tool.
/
" x 8
1
2
Model H0594.
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
#BL8253 PRINTED IN TAIWAN
MODEL H0594
PNEUMATIC JITTERBUG
INSTRUCTION SHEET
Assembly and Attaching Abrasives
To assemble the sander and attach the sand-
paper:
1.
Install a
(not included) into the air inlet.
2.
Press one clamp open, insert one end of the
sandpaper between the clamp and the base
as shown in Figure 2 and release pressure
on the clamp to secure the paper.
/
"
1
2
Figure 2. Attaching sanding sheet.
3.
Fold the sandpaper over the sander, and
secure the paper in the opposite clamp, mak-
ing sure the paper fits snugly as shown in
Figure 3.
Figure 3. Attaching sandpaper on opposite side.
SANDER
⁄
" NPT male quick-disconnect fitting
1
4