Always wear safety glasses
when using this tool to
prevent serious personal
Always disconnect tool from
air to prevent unexpected
operation during service.
Never exceed 120 PSI.
Introduction
This versatile 7" Angle Polisher is a mate to our
H0592 7" Angle Sander. Requires 90 PSI and
consumes 12 CFM. The spindle thread is
UNC and no load speed is 4,500 RPM. Weighs 5
lbs. Air inlet size is
⁄
1
4
Inventory
A. Air Polisher ................................................. 1
B. Pin-Type Spanner Wrench ......................... 1
C. Flat Wrench 19mm ..................................... 1
D. 7" Sanding Pad .......................................... 1
E. Lock Nut ..................................................... 1
F.
Handle ........................................................ 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in Figure 3.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
EYE INJURY HAZARD!
INJURY HAZARD!
EXPLOSION HAZARD!
5
" NPT.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
#TR7990 PRINTED IN TAIWAN
7" ANGLE POLISHER
Quick
Connector
Your
⁄
" x 11
Tool
8
Figure 3.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
MODEL H0593
INSTRUCTION SHEET
Model H0593.
Figure 1.
Quick
Lubricator
Connector
Quick
Coupler
Quick
Air Hose
Coupler
Installing your tool.
Figure 2.
Lubricating directly into air fitting.
Regulator
Air
Compressor
Filter