Grizzly H0592 Instruction Sheet

Always wear safety glasses
when using this tool to
prevent serious personal
Always disconnect tool from
air to prevent unexpected
operation during service.
Never exceed 120 PSI.
Introduction
An excellent air sander that has a free speed of
4,500 RPM. Requires 90 PSI and consumes 12
CFM. Spindle thread nut is
6.5 lbs. Pad size is 7". Air inlet is 1/4" NPT.
Inventory
A. Air Sander .................................................. 1
B. Pin-Type Spanner Wrench ......................... 1
C. Flat Wrench 19mm ..................................... 1
D. 7" Sanding Pad .......................................... 1
E. Lock Nut ..................................................... 1
F.
Handle ........................................................ 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in Figure 3.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
EYE INJURY HAZARD!
INJURY HAZARD!
EXPLOSION HAZARD!
⁄ " x 11 UNC. Weighs
5
8
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
#TR7971 PRINTED IN TAIWAN
MODEL H0592
7" ANGLE SANDER
INSTRUCTION SHEET
Figure 1.
Quick
Quick
Connector
Connector
Your
Tool
Quick
Coupler
Air Hose
Installing your tool.
Figure 2.
Lubricating directly into air fitting.
Figure 3.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Model H0592.
Lubricator
Regulator
Air
Compressor
Quick
Filter
Coupler