Grizzly H0590 Instruction Sheet

EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
injury.
Always disconnect tool from
air to prevent unexpected
operation during service.
Always wear respirator when
Introduction
This 9,000 RPM air sander requires 90 PSI and 6
CFM. Spindle thread nut is
lbs. Pad size is 6". Air inlet is
Inventory
A. Air Sander .................................................. 1
B. 6" Sanding Pad .......................................... 1
B
Figure 1 Model H0590 inventory.
.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
INJURY HAZARD!
DUST HAZARD!
using this tool.
⁄ " x 24 NF. Weighs 4
5
16
/ " NPT.
1
4
A
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
#BL8240 PRINTED IN TAIWAN
MODEL H0590
6" DUAL ACTION SANDER
INSTRUCTION SHEET
Assembly
To assemble the Model H0590:
1. Thread the sanding pad onto the drive spindle
(Figure 2) and tighten with a 17mm wrench.
Figure 2. Installing sanding pad.
2.
Install a ⁄ " NPT male quick-disconnect fitting
1
4
(not included) into the bottom of the sander
handle.
3.
Attach a 6" pressure sensitive adhesive (PSA)
sanding disc to the sanding pad as shown in
Figure 3.
Figure 3. Attaching sanding disc.