Grizzly G9249 Owner's Manual page 29

3.
Figure 32
Note: When using a dead center in the spin-
dle, use a lathe dog so that your workpiece
will rotate with the spindle and not spin on the
dead center tip.
Figure 32.
NOTICE
To avoid premature wear of the dead center
or damage to the workpiece, always keep
the dead center tip well lubricated.
Removing a Sleeve and Center from
the Spindle
1.
2.
3.
Note: Use caution when inserting the bar
stock into the spindle to avoid damaging the
inside surface of the spindle tube.
Tailstock
Installing a Tapered Tool into the
Quill
1.
2.
3.
4.
Figure 33.
5.
6.
Figure 33