Rear Wheel - Yamaha TT-R110EF Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut and
the bolt.
7
1. Brake torque rod
2. Cotter pin
3. Brake torque rod bolt and nut
4. Brake shoe plate
2. Remove the brake pedal free play
EAU25081
adjusting nut, and then discon-
nect the brake rod at the brake
EAU56800
camshaft lever.
EWA10822
1. Brake rod
2. Brake pedal free play adjusting nut
3. Brake camshaft lever
4. Wheel axle
3. Fully loosen the locknut and the
drive chain slack adjusting nut on
both ends of the swingarm.
1. Axle nut
2. Washer
3. Drive chain puller
4. Drive chain slack adjusting nut
5. Locknut
4. Loosen the axle nut.
5. Lift the rear wheel off the ground
6. Remove the axle nut, washer and
7. Push the wheel forward, and then
7-31
1
2 3
according to the procedure on
page 7-28.
the drive chain puller at the left-
hand side, then pull the wheel axle
out together with the drive chain
puller from the right-hand side.
remove the drive chain from the
rear sprocket.
4
5