Table of Contents
Advertisement
Seat
To remove the seat
Remove the bolts, and then slide the
seat to the rear and pull upward.
1
1. Bolt
To install the seat
1. Fit the slot in the seat onto the pro-
jection on the fuel tank, and insert
the projection on the seat into the
seat holder as shown.
INSTRUMENT AND CONTROL FUNCTIONS
EAU46283
1
2
2
3
1. Slot
2. Projection
3. Seat holder
2. Place the seat in the original posi-
tion, and then tighten the bolts.
TIP
Make sure that the seat is properly se-
cured before riding.
Shock absorber assembly
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
Do not tamper with or attempt
Do not subject the shock ab-
Do not deform or damage the
Do not dispose of a damaged or
4-8
WARNING
to open the cylinder assembly.
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
cylinder in any way. Cylinder
damage will result in poor
damping performance.
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EAU46023
EWA10222
4
Advertisement
Table of Contents
Troubleshooting
