Required Tools; Definitions - Siemens ST750 General Handbook

• Personnel should also comply with the Highways National Sector Scheme
Competency Requirements
Training requirements for non UK users may be different

1.4.2 REQUIRED TOOLS

In addition to a standard Engineer's tool kit, the following tools are required when
carrying out any work on the ST750 Controller:
T-bar key
S-18 key – Main Cabinet
Serial handset Techterm, or
Old Oyster handset, or
Larger Screened Oyster handset
Manual Panel key Type 900

1.5 Definitions

Cabinet The ST750 Rack Assembly installed in the ST750 Cabinet with
Assembly associated equipment mounting frame, mounting stool, mains
distribution, power supplies, electronic control and phase switching.
Configuration Data supplied by customer as to how the ST750 is to function.
data (also
referred to as
customer's
data)
and site
specification
EM Controller identification number (ElectroMatic).
Firmware This goes on the Main Processor Board.
EPROM
Pedestrian A group of Red, Amber and Green traffic signals plus their
stream associated Red Man, Green Man and Waits of the pedestrian
signals.
Rack Assembly This consists of a box like frame with a plate hinge on the front that
acts as an access door. The Phase Drive PCB and PSU are mounted
behind the ST750 CPU PCB.
667/HB/33750/000
Part Number
667/2/20234/000
4/MC 289
667/4/13296/001
667/4/13296/000
667/4/13296/002
667/4/13651/000
Page 13
ST750 G H
ENERAL ANDBOOK
Issue 6