Install A Data Cable Between Two Chargers For Power Sharing - Ratio Electric Solar Box Manual

5 . 7 .

Install a data cable between two chargers for power sharing

5 . 7 . 1 . In the Main Controller
1 . Lay down a data cable between the Main Controller and first Sub charger.
2 . Remove the terminal connector of the existing data cable from the charger.
3 . Guide the second data cable alongside the existing data cable through the rubber
grommet.
40 mm 40 mm
4 . Strip the wires of the data cable.
5 . Match the coloured wires to the wires that are already connected to A, B and GND of the
terminal block connector.
Note: Do not connect the +12V wire to terminal 3 of the connector.
6 . Remove the unused wires.
www.ratio-electric.com
27