Additional Testing, Part 15 Subpart B Disclaimer; Mechanical Installation; Electrical Connection; Programmation/Software Integration - Elatec TWN4 MULTITECH NANO LEGIC 42 M Integration Manual

Hide thumbs Also See for TWN4 MULTITECH NANO LEGIC 42 M:

Table of Contents

It is recommended that the host product manufacturer installing the modular transmitter perform some investigative measurements to

confirm that the resulting composite system does not exceed the spurious emissions limits or band edge limits (e.g., where a different

antenna may be causing additional emissions). Detailed information regarding test procedure are described in the relevant rule parts

(refer to Chapter "List of applicable rules").

3.10

ADDITIONAL TESTING, PART 15 SUBPART B DISCLAIMER

TWN4 MultiTech Nano LEGIC 42 M is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant,

and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the

modular transmitter grant of certification. In addition, the final host product still requires Part 15 Subpart B compliance testing with

TWN4 MultiTech Nano LEGIC 42 M installed.

3.11

TWN4 MultiTech Nano LEGIC 42 M is available in two different versions: C0 and C1

Version C0 (SMT)

The version C0 is equipped with solder pads on both sides that enable to integrate (i.e. solder) the module directly onto the PCB or

host device using the SMT technology, whereas the pin connectors on the version C1 are suitable for THT mounting.

For both versions, the components are mounted only on one side of the module to allow an easy integration into the host device.

3.12

3.13

n/a

Version C1 (THT)

Page 5 of 11

Table of Contents

Do you have a question about the TWN4 MULTITECH NANO LEGIC 42 M and is the answer not in the manual?