SCOPE OF DELIVERY ..............................3 1.2.1 COMPONENTS AND ACCESSORIES ........................ 3 1.2.2 SOFTWARE ................................. 3 ELATEC SUPPORT ................................ 3 REVISION HISTORY ..............................3 INTENDED USE .................................. 4 SAFETY INFORMATION ..............................5 TECHNICAL DATA ................................7 MODE OF OPERATION ..............................8 OPERATING MODE ...............................
ELATEC SUPPORT In case of any technical questions, refer to the ELATEC website (www.elatec.com) or contact ELATEC technical support at support-rfid@elatec.com In case of questions regarding your product order, contact your Sales representative or ELATEC customer service at info-rfid@elatec.com...
2 INTENDED USE ELATEC TWN4 MultiTech SmartCard LEGIC 42 is a combination of the TWN4 MultiTech LEGIC 42 (RFID) with an integrated contact card reader/writer (ISO 7816). It allows users to read and write almost any 125 kHz and 13.56 MHz transponders supporting all major technologies from various suppliers like ATMEL, EM, ST, NXP, TI, HID, LEGIC, etc.
The user is liable for the use of spare parts or accessories other than the ones sold or recommended by ELATEC. ELATEC excludes any liability for damages or injuries resulting from the use of spare parts or accessories other than the ones sold or recommended by ELATEC.
Page 6
If you are unsure about any part of the safety information above, contact ELATEC support. Any failure to comply with the safety information given in this document is considered improper use. ELATEC excludes any liability in case of improper use or faulty product installation.
5 MODE OF OPERATION The mode of operation described in the following chapter is based on a standard ELATEC RFID reader equipped with two LEDs. Depending on your product (number of LEDs, installed firmware, etc.) and in case the product settings have been modified with the AppBlaster tool, the information below might differ from your product configuration when in operation.
Page 14
Elatec reserves the right to change any information or data in this document without prior notice. Elatec declines all responsibility for the use of this product with any other specification but the one mentioned above. Any additional requirement for a specific customer application has to be validated by the customer himself at his own responsibility. Where application information is given, it is only advisory and does not form part of the specification.
Need help?
Do you have a question about the TWN4 MultiTech LEGIC 42 and is the answer not in the manual?
Questions and answers