Transmitter And Receiver Binding; Binding - Spektrum AR10360T User Manual

EN
ANTENNA INSTALLATION
The AR10360T receiver has coaxial
style antennas. We recommend
installing the antennas oriented 90º
from each other and as far as possible
from metal, batteries, carbon fiber or
fuel tanks to maximize signal reception performance.
NOTICE: Do not cut, kink, or modify the antennas. Damage to the coaxial
portion of an antenna will reduce the performance of the antenna.
Shortening or cutting off the 31mm tip will reduce the range.

Transmitter and Receiver Binding

Programming the AR10360T receiver requires a Spektrum
compatible transmitter with Forward Programming.

Binding

The AR10360T receiver must be bound to your transmitter before it will
operate. Binding is the process of teaching the receiver the specific code of the
transmitter so it will only connect to that specific transmitter.
1.
Connect up to two optional
SRXL2 remote receivers
(SPM9747 or
SPM4651T) and any
telemetry sensors to
the main receiver.
2.
Push and hold the bind
button on the receiver while
turning the receiver on. Release
the bind button once the orange LED
starts to flash continuously, indicating the
receiver is in bind mode.
TIP: It is still possible to use a bind plug in the bind port if desired. This
can come in handy if the receiver needs to be mounted in a location that is
difficult to access, in which case a servo extension may be used for binding.
If using a bind plug, remove after binding to prevent the system from
entering bind mode the next time the power is turned on.
3.
Put your transmitter in bind mode.
4.
The bind process is complete when the orange LED on the receiver is solid.
6
Active portion
of antenna
DSM2 /DSMX
™ ® ®