Table of Contents
Advertisement
sure the glass slides out of the
supports completely.
8. Clean the glass panels with water
and soap. Dry the glass panels
carefully. Do not clean the glass
panels in the dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
The oven does not heat
up.
The oven does not heat
up.
10.7 Replacing the lamp
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
The back lamp
1. Turn the lamp glass cover to remove
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
4. Install the glass cover.
A
Possible cause
The oven is deactivated.
The Minute Minder + End
of Cooking programmer is
not set.
WARNING!
Risk of electric shock.
The lamp can be hot.
cavity.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
it.
°C heat-resistant lamp.
Remedy
Activate the oven.
Set the Minute Minder +
End of Cooking program‐
mer. Refer to the chapter
"Clock functions".
ENGLISH
21
Advertisement
Table of Contents
