Record Set Item - JVC GY-HM660E Instructions Manual

Date/Time
For setting the year, month, day, hour, and minute.
Memo :
If the signal reception for GPS satellites allows
0
date and time to be set based on the GPS
information, you can set the time obtained from
the GPS satellite by pressing the [FOCUS
ASSIST/1] button.
The [FOCUS ASSIST/1] button is grayed out if
information for setting the date and time cannot
be acquired from the GPS satellite. l
The display order of the date (year, month, day)
0
follows the setting in [Display Settings] B [Date
Style]. However, the 24-hour format is used for
the hour display regardless of the [Time Style]
setting.
(A P111 [ Date Style ] )
Time Zone
For setting the UTC time difference in units of 30
minutes.
[Setting Values: UTC-12:00-UTC-00:30, UTC,
UTC+00:30-UTC+14:00 (in 30 min increments)]
(Default values: UTC-05:00 (U model), UTC (E
model))
Memo :
If [Date/Time] is already set, the [Date/Time]
0
item is automatically adjusted when [Time
Zone] is altered.
Reserved
For setting the additional function to "On" or "Off".
9 Reserved 1 to Reserved 16
Normally set to "Off".
[Setting Values: On, ROff]
System Information
9 Version
Displays information on the firmware version.
9 Fan Hour
For displaying the usage time of the internal fan.
Memo :
Under normal environment, dust will
0
accumulate on the internal fan when the camera
recorder is used over a long period. Dust may
enter the camera recorder especially if it is used
outdoors. This may affect the image and sound
quality of the camera recorder. Check and
replace the fan after every 9000 hours
(suggested guideline).
9 Open Source License
Displays the license for the open source software
used by this camera recorder.

Record Set Item

Record Format
After setting of all items in the [Record Format]
menu is complete, select [Set] at the bottom of the
screen to apply the new settings on the camera
recorder and switch the recording format. A
"Please Wait..." message appears during
switching.
9 System
For selecting a system definition.
HD:
0
Records in "HD" (high definition) quality
SD:
0
Records in "SD" (standard definition) quality
HD+SD a ：
0
Records in "HD" (high definition) for slot A, and
in "SD" (standard definition) for slot B.
HD+Web a ：
0
Records in "HD" (high definition) for slot A, and
in low definition for slot B.
[Setting Values: RHD, SD, HD+SD, HD+Web]
Caution :
The setting value options for each of the
0
following item vary depending on the setting of
this item.
a : [WFormat], [WResolution], [WFrame & Bit
Rate]
b : [Format], [Resolution], [Frame & Bit Rate]
117