JVC GY-HM660E Instructions Manual page 111

TC/UB
For specifying whether to display the time code
(TC) or user's bit (UB) rate in the display on the LCD
monitor and viewfinder screen.
[Setting Values: UB, RTC, Off]
Audio Meter
For specifying whether to display the audio level
meter on the LCD monitor and viewfinder screen.
[Setting Values: ROn, Off]
Battery
For setting the display of the remaining battery
power in the display on the LCD monitor and
viewfinder screen.
The battery information appears only on the
Display 2 screen in Camera mode.
(A P131 [Display 2 screen] )
Time:
0
Displays the remaining battery power in
minutes. (min)
Capacity%:
0
Displays the remaining battery power in
percentage. (%)
Voltage:
0
Displays the current battery voltage in units of
0.1 V. (V)
Off:
0
The remaining battery power is not displayed.
[Setting Values: RTime, Capacity%, Voltage, Off]
Memo :
The battery mark that appears before the "Time",
0
"Capacity%" or "Voltage" value changes
according to the remaining battery power.
In addition, the plug mark is added during
charging.
: 10 % and below
4 S
: 11 % to 30 %
D R
: 31% to 70 %
C Q
: 71 % to 100 %
B P
When the remaining battery power is low, "RES"
0
instead of the value is displayed.
Replace the battery as soon as possible.
The remaining battery power and remaining
0
time are intended as reference values for the
shooting duration.
The time, capacity or voltage will not be
0
displayed during charging.
Date/Time
For specifying whether to display the date and time
in the display on the LCD monitor and viewfinder
screen.
[Setting Values: ROn, Off]
Date Style
For setting the date display sequence for display
on the LCD monitor and viewfinder screen as well
as for time stamp recording.
Display examples of the setting values are as
follows.
DMY2: 30 Jun 2018
0
DMY1: 30-06-2018
0
MDY2: Jun 30, 2018
0
MDY1: 06-30-2018
0
YMD: 2018-06-30
0
[Setting Values: DMY2, DMY1, MDY1, MDY2,
YMD]
(Default values: MDY2 (U model), DMY1 (E
model))
Time Style
For setting the time display for display on the LCD
monitor and viewfinder screen as well as for time
stamp recording.
[Setting Values: 24hour, 12hour]
(Default values: 12hour (U model), 24hour (E
model))
Shutter
For setting the shutter display to be displayed on
the LCD monitor and viewfinder screen.
DEG:
0
Displays the shutter speed in degrees in the
same way as film cameras.
SEC:
0
Displays the shutter speed in seconds.
[Setting Values: DEG, RSEC]
Memo :
"DEG" is selectable only when [WFrame & Bit
0
Rate] is set to "24p" or "25p".
When [WFrame & Bit Rate] is set to other values,
the shutter display setting is fixed at "SEC" and
cannot be selected.
(A P118 [WFrame & Bit Rate a, Frame & Bit
Rate b] )
111