Pairing The Wireless Subwoofer With The Soundbar - JVC TH-WL707H Instruction Manual

Pairing the Wireless Subwoofer with the Soundbar

Automatic Pairing
Plug the soundbar and the subwoofer into the mains sockets and switch on the subwoofer.
on the unit or on the remote control to switch the unit to On mode. The display will
Press
show "WELCOME". Then the subwoofer and soundbar will automatically paired within 30
seconds.
Do not press PAIR on the rear of the subwoofer, except for manual pairing.
Manual Pairing
It is very abnormal that the connection would fail, you should not attempt manual pairing in normal
usage.
If the automatic pairing fails or the subwoofer is switched OFF, the display will flash "CHK
SUB" for 20 seconds. Ensure that all the cables are well connected, the main unit and the
subwoofer is switched to On mode. If it still doesn't work, pair the subwoofer with the
soundbar manually.
1. Unplug both units from the mains sockets, then plug them in again after 3 minutes.
2. Press and hold the PAIR button on the rear of the subwoofer, and then press and hold
and SOURCE on the unit for a few seconds to start pairing. The pair indicator on the
subwoofer will rapidly blink when pairing and will become solid when successful.
3. While the unit is pairing with the subwoofer, "CNCT SUB" will flash on the display.
4. After the subwoofer is paired with the unit, "CNCT SUB" will disappear, and the display
will show the current channel.
• After connecting the power, you must press PAIR on the subwoofer within 20 seconds to be effective.
• The subwoofer should be within 5 m of the soundbar in an open area.
• If the wireless connection fails again, check if there is conflict or strong interference (for example,
interference from an electronic device) around your location. Remove these conflicts or strong
interferences and repeat the above procedures.
GB
17