Ezdispense - LG F6V910WTSA Owner's Manual

global_main.book.book Page 67 Monday, May 10, 2021 9:22 AM

ezDispense

Symptoms
Refill Alarm
continues to
display when
detergent/
softener is added.
Too much/too
little detergent or
softener
dispensed.
The ezDispense
doesn't dispense
detergent/
softener.
There's foam on
the rinsing course,
and there's
detergent left on
the clothes after
the washing.
After the washing,
there's a scum on
the cloth.
Possible Cause & Solution
Detergent/softener has built up on the fluid level sensor.
• Open the compartment covers and clean the insides of the
ezDispense compartments with warm water. Use a soft
brush to remove any residue. If the Refill Alarm is
displayed continuously, call for service.
The amount of detergent/softner is not enough for the
sensor to detect.
• Fill the detergent/softner up to the MAX line in the
compartment.
The default dispense amounts setting may need to be
changed.
• Check and change the default dispense amounts setting.
The ezDispense function is off.
• Turn on the ezDispense function.
The ventilation holes are blocked.
• Clean the ventilation holes for the lids on the
compartments with warm water.
The detergent or softener in the ezDispense
compartments has hardened.
• Clean the ezDispense compartments and change the
detergent or softener.
Detergent was used when rinsing.
• Please make sure that the detergent/softner is stored
correctly. (right: detergent / left: softener)
You need to clean the inside of the ezDispense system.
• When using both dispensers for liquid detergent, make
sure to run the ezDispense Nozzle Clean in advance.
TROUBLESHOOTING
67